Mace MAS-WA-SYS Uživatelská příručka stáhnout pdf (Strana 19)

Keys Description Note

(1234 or 4-digit

PIN) +

You must be in STANDBY

mode before enrolling a new

Remote Control onto the

Wireless Alarm Panel

*To make sure you are in STANDBY mode:

- Enter the default PIN “ 1–2–3–4 ” OR your new 4-digit PIN

- Press

- The panel will display the below image while you are in

STANDBY mode:

(One beep indicates that you entered a valid PIN, three beeps

indicate that an invalid operation was performed).

(1234 or 4-digit

PIN) +

Enter the default PIN

“ 1–2–3–4 ” OR your new

4-digit PIN for setting

followed by

The panel will display the below image:

Press then to enter

the Remote Control Enroll

mode. Then press any key on

the new Remote Control to

enroll it onto the system.

LCD display ﬂashes the ID no. of the remote to be enrolled

e.g. when enrolling the ﬁrst remote ID no. “01” will ﬂash. Once

the ﬁrst remote is enrolled the “02” will ﬂash ready for a second

remote to be enrolled (One beep indicates that the remote was

enrolled to the panel successfully)

Note: It is recommended that the ID No. is marked on the

remote in case it needs to be deleted at a later stage

Press to complete the

setting

Conﬁrm the setting and return the panel to STANDBY

by pressing

iii. OPeratinG the keychain remOte cOntrOl

The remote can be used to arm, disarm, and operate the system instantly.

ARM:

Pressing the ARM button on the remote will arm the system, triggering the preset exit delay.

When triggered the Wireless Alarm Panel’s LCD display will ﬂash Red and indicate the triggered zone.

DISARM:

Pressing the DISARM button on the remote will

disarm the system instantly and the system will

return to STANDBY mode.

ALERT:

Pressing the ALERT button on the remote will put

the system into ALERT mode and a chime will

sound if any of the sensors are triggered. The LCD

display will ﬂash Green and indicate the triggered

zone.

HOME:

Pressing the HOME button on the remote will set

the system in HOME mode which will operate the

system in both ARM and ALERT modes in different

preset zones.

PANIC:

If the HOME and ALERT buttons are pressed together the systems alarm is immediately activated.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Komentáře k této Příručce

Žádné komentáře

Mace MAS-WA-SYS Uživatelská příručka Strana 19

Komentáře k této Příručce